Our operators have a minimum of one to two years’ experience. They also need to know maintenance requirements and operation of the equipment. 

The forming process requires one or two persons depending on the weight of part. One experienced operator or a helper. This is machine can be ran by one or two persons. If by two, both persons communicate with each other to perform the task.


Click to Expand
Plate Rolling Procedure

Before use, the operator must inspect the equipment and check for prober operation. The machine needs to check for service (greasing, hydraulic fluid, and leaks). 

Drawing review 

The operator must review the drawing to understand the task at hand. The operator know the following:

  1. Material type and wall thickness
  2. Blank Size of plate (width and length)
  3. Radius or diameter
  4. Weight
  5. Special instructions 

The following be known to perform the task at hand.

Determine Capacity

Estimating capacity requirement is determined by operator and management. Management will use the section modules to determine capacity. There are manufacturing charts available. This is important for a safe production of the part.

Preforming Ends

The plate is put into the roll and each end is pre-formed to the specified radius. Each end must be      pre-formed correctly and checked with a template.


After pre-forming continue to roll the plate into a cylinder take multiple passes. Once rolled to butt fit the seam and tack. The operator can reroll after tacking.



After welding the operator may have to reroll the cylinder. The roll is opened and the cylinder is placed into the roll. The roll turns and the operator measured roundness in several places and applies pressure where ever needed. 

Take notes of your set up procedure for future use. This will help later on and add to the bottom line


Contact Paramount Roll to learn more about our plate rolling procedures

Leave a Reply

Your email address will not be published. Required fields are marked *

Have a Pipe Rolling or Beam Bending Job?

Contact Us Now